Page 1 of 1
Pump Bearings
Posted: Mon Feb 18, 2008 9:13 pm
by tomy2ponds
Hi All I have found a company who can supply bearings for Sequence pumps Recently my Sequence 10.000/750 became noisy and having striped it down i found a worn rusty bearing.Having asked a few people where can i get some and being told they don't know, I went on the Internet to see what I could find.
Well I have a set of bearings coming total cost £8.52.
Duncan if it OK with you I will post there details.Please let me know if this is OK
Posted: Tue Feb 19, 2008 8:25 pm
by tomy2ponds
Hi All my bearings arrived today just over 24 hours after I placed the order.I have fitted them into my pump and all is silent again.
Here is the company's address www.simplybearings.co.uk
I hope it is OK posting this but if you need bearings for your pump this company were very happy to help
Posted: Wed Feb 27, 2008 11:47 pm
by EREN
Hi tomy2ponds
Thats just what i was looking for ,what was the part number or the size that you order
Thanks Eren
Posted: Fri Feb 29, 2008 12:25 am
by tomy2ponds
Hi Erin your pump is a different model to mine so you will need to strip the pump and motor down and measure the bearings noting anything that is written on the casing of the bearing.Then if you phone the company they will be able to help you.you may need a bearing puller to get the old bearings off.
Posted: Sat Mar 01, 2008 12:42 pm
by B.Scott
He have a dealer for SK bearings right around the corner. Surprising how little those suckers cost. I have gotten them in the past for my washer, drier and the trailer of the boat I used to have. Cheap as chips when you think about it.
B.Scott
Posted: Sat Mar 01, 2008 7:44 pm
by tomy2ponds
Hi Scotty when you consider a new pump is around £180 it is very cheap
Posted: Sat Mar 01, 2008 8:54 pm
by B.Scott
Absolutely!
Re: Pump Bearings
Posted: Tue May 19, 2009 8:55 pm
by daz2007
my sequence pump has been getting rather noisy and on sunday finally stopped and thanks to this post
a quick stripdown and a phone call on monday morning to simplybearings and new part ordered plus one for
a spare. arrived today and pump rebuilt and back on the pond great service from them thanks again to
tommy2ponds for this post my pump was a 8000s with a.o.smith motor.
Re: Pump Bearings
Posted: Tue May 19, 2009 10:03 pm
by tomy2ponds
Hi Daz i made this post in feb 2008 just go's to show how useful koi forums are
Re: Pump Bearings
Posted: Tue May 19, 2009 10:27 pm
by daz2007
yes they are a great source for info
i did notice how old the post was but the info is still good.